It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
- Keep out of excessive sunlight.
- Do not apply to surfaces that may reach excessive temperatures such as hot-water pipes or stoves
- Do not use on surfaces where contact can occur with food or food-preparation utensils.
Where to Use
Indoors: Apply gel in area where ants are seen. Areas include behind the refrigerator and stove, around water pipes, in cracks and crevices, around window frames, along baseboards and shelves.
Outdoors: Where ants are seen entering the building, directly on ant nests, and in cracks and crevices on windows and doorsills.
How to Use: Remove cap from the tip of the tube. Place plunger into rear of tube. Place tip at spot where gel is to be applied and depress plunger. Apply gel in pea-sized droplets. Inspect gel regularly and replace as needed. Replace cap on gel tip when finished dispensing gel. Use a paper towel to remove unwanted bait placements and then discard in trash.
Note: This product will not control carpenter, pharaoh, harvester or red imported fire ants.
To apply gel, remove cap from tip of applicator tube. Place plunger into rear of tube. Place tip at spot where gel is to be applied and depress plunger. Apply gel in a ¼-inch diameter spot. Apply one spot for every 10 sq ft of treated area. The bait will stick to surfaces that are not greasy or dusty.
For best results, do not apply bait to areas recently treated with an insecticide or treat areas with an insecticide where gel has been applied. This will act as a repellent to the roaches and will reduce the effectiveness of the gel bait. Apply behind and under the following: stoves, refrigerators, dishwashers, sinks, shelving in the corners of cupboards, cabinets and closets and in other areas where roaches have been observed. Inspect placements after one month and reapply if gel placements are no longer visible. The gel will remain attractive to roaches and keep killing for up to three months. Replace cap on gel tip when finished dispensing gel. Use a paper towel to remove unwanted bait placements and discard them in trash.
Cracks and Crevices
This product can be applied as spots or as a line along cracks and crevices. Place the applicator tip directly into cracks and crevices and place gel in small spots or in a continuous bead. Bait should be in the void area and not on open or exposed surfaces.