1993,94,95,97 models need to use part# FM3050
(All information and images contained in this site is property of Hotshot Performance, Inc. copyright 2004)
NOTE: All Hotshot
Performance items are intended for off road use only. Hotshot Performance will
not be responsible for any consequences
resulting from your failure to comply with your federal, state, and local laws.
Hotshot Performance recommends that trained professionals perform the installation
of mechanical parts, as improperly installed products may lead to unsafe and
unreliable conditions. Warranty will not be honored for damage or malfunctions
due to improper installation, misuse, unauthorized repair or alterations.
NOTE: BEFORE TOUCHING
YOUR CAR, PLEASE READ THE FOLLOWING PROCEDURES
Basic Installation Instructions
1) Raise vehicle and secure with jackstands or a lift. Be sure to soak all bolts, nuts, fittings, etc with penetrating oil.
2) Disconnect positive battery cable from battery.
3) Remove heat shields from manifolds.
4) Remove cross member (6 bolts).
5) Unplug and remove O2 sensors from stock manifolds.
6) Remove y-connector pipe from stock manifolds.
7) Remove EGR tube from engine block.
8) Install new gaskets onto heads. install headers onto studs, and tighten.
Install O2 sensors into headers and Secondary, and plug into harnesses.
9) Insert Y-pipe hanger rod into stock rubber hangers, and attach the 2 bolts
that connect to the stock cat. converter.
10) Using supplied bolts and gaskets, attach y-pipe to headers and tighen EVENLY.
Install supplied EGR tube into rear header and engine block.
11) Re-install cross member ( 6 Bolts).
12) Visually inspect all connections to make sure everything is connected,
and tightened securely. Re-connect battery and lower vehicle.
13) Start vehicle and check for leaks.